Appliance manuals and free pdf instructions. Find the user manual you need for your home appliance products and more at ManualsOnline. Hoover Floormate H3000 Instruction Manual Our system has returned the following pages from the Hoover H3000 data we have on h3000 bare floor cleaner manual hoover h3000 floormate instructions. One kind of hoover vacuum instruction manual is always that which comes with a HOOVER FLOORMATE SPINSCRUB H3000 MANUAL. Has been read.
Advertising
37
38
39
Cleaning the brushes
The brush assembly can be removed for easy cleaning. Turn cleaner OFF and disconnect from electrical outlet. Place handle in the upright position. Remove tanks to prevent leaking. Set aside.
Pull the two nozzle release buttons (A) out. Remove nozzle.
Tilt cleaner back so handle rests on floor.
Push two brush release buttons (B) and remove the brush
assembly.
The brushes can be washed with a mild detergent and rinsed. Do
not use a solvent based detergent.
To replace brushes, align post (C) on brush block with hole
(D) on bottom of cleaner. Turn brushes slightly until post
fits easily into hole. Press brush assembly firmly to snap into
place.
37
38
39
A
B
C
D
A
40
41
Return cleaner to upright position. Replace nozzle,
Hoover H3000 Instructions
making sure latches (E) are out.
Align middle section (F) of nozzle with opening (G) on
cleaner.
While holding nozzle in place, slide latches inward
to lock in place.
Replace tanks.
40
41
E
F G
E
16
Advertising
This manual is related to the following products:
Popular Brands
Popular manuals
Hoover H3000 Manual
Advertising
Recovery (lower) tank
Automatic shut-off
An automatic suction shut-off is built into the recovery
Hoover Floormate Model H3000 Parts
tank to prevent the tank from overflowing. When the shut-off activates, the cleaner will not pick up
debris and the sound of the motor will change. The recov-
ery tank is full and must be emptied.
How to empty
Turn cleaner off and disconnect from electrical outlet.
Although not necessary for satisfactory performance, it is
recommended that the recovery tank be emptied after dry
vacuuming and before wet operation.
Check the solution tank also. It may need to be refilled at
this time.
To remove tank, press down on release button (B) and
pull tank straight out.
Remove tank lid (C). Empty tank.
The tank lid contains a washable, reusable filter. Clean this
filter when suction is low or reduced. Turn cleaner off and disconnect from electrical outlet.
Remove recovery tank and lid (Figs. 24 & 25). Remove
filter lid (A), then remove filter (B). Remove loose
debris from filter by tapping the filter or gently brushing
using your hand. The filter may also be rinsed for addition-
al cleaning. Allow filter to air dry between uses.